JN0-362 is a new exam for the Juniper Networks Certified Specialist, Service Provider Routing and Switching (JNCIS-SP) certification, it is a replacement exam of JN0-361. Now Passcert new released JNCIS-SP Certification JN0-362 Dumps which give you experience of taking the exam and help you to earn high score without spending extra money and time. You will get best preparation and feel confident in attempting Juniper JN0-362 Exam with the guidance of Passcert. JNCIS-SP Certification JN0-362 Dumps provide you the gateway to success in actual JN0-362 Certification Exam.

Service Provider Routing and Switching, Specialist (JNCIS-SP) is designed for experienced networking professionals with beginner to intermediate knowledge of routing and switching implementations in Junos, this written exam verifies the candidate’s basic understanding of routing and switching technologies and related platform configuration and troubleshooting skills.

Exam code: JN0-362

Written exam

Administered by Pearson VUE

Exam length: 90 minutes

Exam type: 65 multiple-choice questions

Pass/fail status is available immediately

Junos Software Release: 19.4

 

Protocol-Independent Routing

Open Shortest Path First (OSPF)

Intermediate System to Intermediate System (IS-IS)

Border Gateway Protocol (BGP)

Layer 2 Bridging or VLANS

Spanning-Tree Protocols

Multiprotocol Label Switching (MPLS)

IPv6

Tunnels

High Availability

1. You have configured multiple IP-IP tunnels across your network to provide connectivity to remote sites. Which technique is used to help the IP endpoints in your network determine the optimal packet size to send across your tunnels?

A. path MTU discovery

B. fragmentation discovery

C. end-to-end MTU discovery

D. packet throughput discovery

Answer: A

2. To prevent fragmentation issues across a GRE tunnel, which MTU value is recommended for the tunnel to accommodate most IP packets?

A. 1476

B.1492

C. 1500

D. 1524

Answer: D

3. Which two statements are true about the LACP protocol? (Choose two.)

A. It exchanges BPDUs to ensure all member links are functioning properly.

B.  It monitors and controls the member links that form a single logical channel.

C. It acts in one of two modes: active and passive.

D. It is used to exchange control information between two MC-LAG network devices.

Answer: BC

4. Which three protocols can be encapsulated within a GRE tunnel on a Junos device? (Choose three.)

A. AppleTalk

B. Aggregated Ethernet

C. IPv6

D. MPLS

E. Ethernet

Answer: ACD

5. In the evaluation of an RSTP configuration BPDU, which two values are contained in the Bridge ID value? (Choose two)

A. root bridge address

B. priority

C.originating bridge address

D. port number

Answer: BC