NSE4_FGT-6.2 Fortinet NSE 4 - FortiOS 6.2 exam is the new NSE 4 Certification exam instead of NSE4_FGT-6.0 which has been retired. Passcert new released Fortinet NSE4_FGT-6.2 Dumps will help you in earning the NSE4_FGT-6.2 certification in the first attempt. It is the most significant way to prepare for your NSE 4 Certification NSE4_FGT-6.2 Exam and you will feel more confident to pass your Fortinet NSE4_FGT-6.2 exam successfully with high scores.

We recommend this course for network and security professionals who are involved in the day-to-day management, implementation, and administration of a security infrastructure using FortiGate devices. You must successfully pass the NSE4_FGT-6.2 Fortinet NSE 4 -  FortiOS exam to earn your NSE 4 certification.

Exam series: NSE4_FGT-6.2

Number of questions: 70

Time allowed to complete: 120 minutes

Language: English and Japanese

Status: Available

A. Web filtering

B. Antivirus

C. Web proxy

D. Application control

A. In proxy-based inspection mode antivirus buffers the whole file for scarring before sending it to the client.

B. In flow-based inspection mode, you can use the CLI to configure antivirus profiles to use protocol option profiles.

C. In proxy-based inspection mode, if a virus is detected, a replacement message may not be displayed immediately.

D. In quick scan mode, you can configure antivirus profiles to use any of the available signature data bases.

A. This setup requires at least two firewall policies with the action set to IPsec.

B. Dead peer detection must be disabled to support this type of IPsec setup.

C. The TunnelB route is the primary route for reaching the remote site. The TunnelA route is used only if the TunnelB VPN is down.

D. This is a redundant IPsec setup.

A. Configure split tunneling for content inspection.

B. Configure host restrictions by IP or MAC address.

C. Configure two-factor authentication using security certificates.

D. Configure SSL offloading to a content processor (FortiASIC).

E. Configure a client integrity check (host-check).

A. They can inspect HTTP traffic.

B. They can redirect blocked requests to a specific portal.

C. They can block DNS requests to known botnet command and control servers.

D. They must be applied in firewall policies with SSL inspection enabled.

A. To remove the NAT operation.

B. To generate logs

C. To finish any inspection operations.

D. To allow for out-of-order packets that could arrive after the FIN/ACK packets.